Blue Expert EDC620CM Manual De Instrucciones página 2

1-Safety
1.1 Designated application
The electro-hydraulic crimping tools «blue expert» are exclusively used for the production of
crimping connectors. The tool is only suitable for manual operation and after a series of approx.
40-50 press cycles, it must be allowed to cool down for about 10 minutes.
Please take the rules and regulations of those countries in which the crimping tool is to be
used, as well as the information in the operating instructions, into account, so that the tool may
be used correctly and safely.
For reason of safety, the battery-powered crimping tool may only be serviced by authorised
specialist workshops. Any unauthorised modifications or the opening of the tool by the user will
lead to a loss of the product liability.
1.2 Safety Instructions
Explanation of the Symbols
Risk of injury and
crushing
Service
Reset
1.3 Dangers
All persons that work with this tool or carry out servicing on it must be appropriately instructed
in their work and must read, observe, and understand the operating instructions. Non-
observance of these instructions or faults caused by unqualified staff may lead to damage to
health, incorrect tool usage and damage to the property of others or to the tool.
1.4 Sources of danger
The battery-powered crimping machine itself has a voltage of 14.4 Volts, and the charger is operated
on 230V, 50Hz. Since the battery-powered crimping machine operated with a high pressure, parts of
the body must not be allowed to come into the area of the crimping head or the pressing dies.
The tool: - must not be cleaned when wet
- may only operated using a battery P/N BL1426 or mains power lead P/N CA22005
- must not be used in surroundings where there is a risk of explosion
- must be protected against heat, water, damp and corrosive surroundings.
- must be treated carefully
- must not be thrown
The power cable of the charger must not be used for pulling out the plug and must be protected
against corrosive Liquids, oils and sharp objects.
1.5 In case of an Emergency/Protective devices
In an emergency case, the tool will automatically stop when the operating switch is released.
When the emergency push button at the slide is depressed, the pressure on the hydraulic
cylinder is released in order to retract the ram and to release the crimping dies. The front
protective frame at the handle will protect the hand at the front part of the tool. The typical A-
weighted noise level averages not more than 70dB (A). The noise level can over travel 85 dB
(A) during the working process. The weighted effective value of the acceleration averages not
more than 2.5 m/s².
Specialist disposal of the battery
Read operating instructions
2- Scope of delivery