Publicidad
Idiomas disponibles
Idiomas disponibles
SP6683 DIRT HOUND.qxd
1. Locate blowing port of your vac.
2. Insert the male/male adapter into the
locking tab adapter end of the hose.
Insert the opposite end of the male/male
adapter into the blowing port of the vac.
3. (Optional) Attach extension wand to
opposite end of hose, then place the
blower nozzle on the wand.
4. Turn vac on and you are ready to use
your vac as a blower.
Filter
!
WARNING: To reduce the risk of
injury
from
unplug power cord before changing
or cleaning filter.
NOTE: The filter is made of high quality
material designed to stop small particles of
dust. The filter can be used for wet or dry
pick up. Handle the filter carefully when
removing to clean or installing a new filter.
Creases in the filter pleats may occur from
installation but creases will not affect the
performance of the filter.
Cleaning
Your filter should be cleaned often to
maintain peak vac performance.
Be sure to dry the filter before storing or
picking up dry debris.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use a
filter with holes or tears in it. Even a small
hole can cause a lot of dust to come out of
your vac. Replace it immediately.
6/27/07
1:49 PM
Operation
Maintenance
accidental
starting,
Page 10
(continued)
Blowing
Nozzle
Removal
To remove the filter for cleaning or
replacement, unscrew the filter nut from
the filter cage, remove filter plate and lift
off filter.
!
WARNING:
Do not operate with
the filter cage and float removed. The
float prevents water from entering
the impeller and damaging the
motor. The cage prevents fingers
from touching the moving impeller.
IMPORTANT: To reduce the risk of
damage to the blower wheel and motor,
always reinstall the filter before using the
vac for dry material pickup.
Cleaning A Dry Filter
1. Some removal of dry debris can be
accomplished without removing the filter
from the vac. Slap your hand on top of
the power assembly while the vac is
turned off.
2. For best cleaning results due to
accumulated dust, clean the filter in an
open area. Cleaning SHOULD be done
outdoors and not in the living quarters.
10
Male/Male
Locking Hose
End
Swivel End
of Hose
Extension
Wand
Publicidad
