Descargar Imprimir esta página

Herschel ADVANTAGE IR2 Instrucciones De Instalación Y Funcionamiento página 4

Ocultar thumbs Ver también para ADVANTAGE IR2:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
on a wall. DO NOT MOUNT POINTING VERTICALLY DOWNWARDS. The heater is not designed for ceiling
mounting.
In areas with air movement/wind the directional Far Infrared spread may reduce by 1/3 to 1/2. In these
areas we recommend mounting at the lowest recommended height (see diagram 1) and proportionally
increasing the number of heaters.
CAUTION:
• Ensure mains power is OFF before commencing installation.
Heater must not be located immediately below a socket outlet.
Joists, beams and rafters shall not be cut or notched to install the appliance.
Do not install the Advantage IR into a ceiling recess, nor adjacent to a heater that has been ceiling-
recessed.
The identification mark and model reference should be visible after installation.
The Herschel Advatage IR must not be attached so as to face or be close to any combustible material
(eg, wood or PVC cladding, fascia or soffit).
The fixed wiring insulation coming into contact with parts with a temperature rise of greater than 50°C
must be protected, for example, by sleeving having an appropriate temperature rating.
Diagram 1.
EXTERIOR USE:
The unit is protected against water ingress (protection level IPX4), however it is recommended that the unit
is installed in a covered outdoor area to give maximum protection and longevity against the effects of driving
rain, wind, frost, salt water contamination, etc. The canopy/roof/cover must be of a permanent nature,
there must be a minimum clearance of 0.3m (12") between the cover and any part of the Advantage IR and
the cover must extend a minimum of 2m (79") from the wall.
INITIAL USE:
There may be an odour or vapour from the heater on initial use or if heater has not been used for an
extended period. This is normal and is a result of a build up of dust.
USER MAINTENANCE:
The Herschel Advantage IR is maintenance free but to maintain appearance it should occasionally be cleaned
all over with a soft dry cloth. No abrasive cloths or cleaners should be used and appliances such as pressure
ENGLISH

Publicidad

loading

Este manual también es adecuado para:

Advantage ir3