Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing of Installation
Read these instructions completely and carefully.
Freezer Location
Your freezer should be conveniently located for
day-to-day use in a dry, well-ventilated room.
Do not install the freezer where the temperature will go
below 0°F (-18°C) or above 110°F (43°C), because it will
not maintain proper temperatures.
Level Freezer
Level the freezer from side to side and front to back
so that the lid will seal properly. Use shims to level the
freezer if necessary.
Clearances and Ventilation
Allow at least 2" (50.8 mm) clearance on both sides of
the freezer and 2" (50.8 mm) between the back of the
freezer and the wall. Leave room above the freezer to
open the lid.
Keep flammable materials and vapors, such as gasoline,
away from freezer.
Lid Removal
CAUTION
LIFTING HAZARD
The lid is heavy. Use both hands to secure the lid before
lifting.
CAUTION
HINGE SPRING UNDER TENSION
If it is necessary to remove the lid, follow these steps:
1. R emove the lower part of the hinge cover and then
remove the upper part.
8
Do not install the freezer in a location exposed to rain
water or direct sunlight.
Be sure to install your freezer on a floor strong enough
to support it when it is fully loaded.
NOTE: It should not be necessary to remove the lid
during installation. If, for some reason, the hinges need
adjustment, call a professional service company..
Do not cover the freezer with items such as blankets,
sheets, tablecloths, etc. This reduces air circulation.
2. O pen the lid to the maximum position. (The hinges are
loosest at this position.)
3. R emove the 4 screws from the upper part of the hinge
and lid.
Upper Hinge
Cover
Lower Hinge
Cover
4. T o reinstall lid follow steps in reverse. Tighten all
hinge screws but avoid over-tightening to prevent
stripping. Reinstall hinge covers.
Hinge Screws to
be Removed
49-1000650 Rev. 0
Publicidad
