G Operating instruction
Thank you for choosing a ISY product.
Take your time and read the following instructions and
information completely. Please keep these instructions in a
safe place for future reference. If you sell the device, please
pass these operating instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to
draw your attention to specific hazards and risks.
Danger
This symbol (with possible additional symbols) indicates
an immediate danger that leads to serious personal
injuries or death.
Note
This symbol is used to indicate additional information or
important notes.
2. Package Contents
• TV wall bracket
• Wall plate cover (3x)
• Installation kit (see contents, Fig. 1)
• These operating instructions
Note
Please check that the installation kit is complete before
installing the bracket and ensure that none of the parts
are faulty or damaged.
3. Safety Notes
Warning
• Given the multitude of terminal devices and wall
structures available on the market, the supplied
mounting kit is unable to cover every option.
• It occasionally happens that the screws for attaching
the terminal device to the wall bracket are too long.
• Please note that the supplied wall plugs are for use
with concrete brick and solid brick walls only.
• Read the operating instructions for your terminal device
before attempting to mount it. The instructions provide
information about the type and measurements of
suitable fastening materials.
• If the supplied mounting kit does not contain suitable
fastening materials for mounting the terminal device,
purchase these from a specialised dealer.
• If the wall on which the bracket is to be mounted is made
of different material types and construction types to
those specified, purchase suitable mounting materials
from a specialised dealer.
• Never apply force during mounting. This can damage
your end device or wall bracket.
• If in doubt, have this product mounted by a qualified
technician - do not attempt to mount it yourself!
2
Danger
• Danger of serious personal injuries and death through
the TV set and/or TV wall bracket falling.
• If the product is improperly mounted and/or is mounted
using material that is unsuitable or inadequately
dimensioned for the wall construction and/or by a
person who does not have the necessary competence
to properly mount the product and/or without
observing the safety information set out in these
instructions, the TV set and/or the TV wall bracket can
fall without prewarning.
• Only mount the product yourself if you have adequate
expert knowledge to mount the product, and are able
to select suitable mounting material and ensure safe,
long-lasting product mounting.
• Otherwise engage a construction expert to mount the
product and to select suitable mounting material.
• Keep children away from the product during mounting
and subsequent operation. The product is not a toy!
• Always make sure that people including children never
linger beneath or near the product during mounting and
subsequent operation. If necessary, block off the hazard
area with suitable material.
• When mounting the product, hanging up the TV set
and checking safe mounting, wear safety shoes and a
safety helmet.
• Following a different procedure or disregarding this
safety information constitutes negligence!
• Do not mount the product above locations where persons
might linger.
• Once you have mounted the product and the attached
load, check that they are sufficiently secure and safe to
use.
• You should repeat this check at regular intervals
(at least every three months).
• When doing so, ensure that the product does not exceed
its maximum permitted carrying capacity and that no load
exceeding the maximum permitted dimensions is attached.
• Make sure that the product is loaded symmetrically.
• During adjustment, ensure that the product is loaded
symmetrically and that the maximum permitted carrying
capacity is not exceeded.
• Maintain the necessary safety clearance around the
attached load (depending on the model).
• In the event of damage to the product, remove the
attached load and stop using the product.