Publicidad
Idiomas disponibles
Idiomas disponibles
7
7. Pour the box of lava rocks (F) into the firebowl (A).
CAUTION
To ensure proper function, the guard (E) on this
burner (D) should be free of lava rocks at all times.
Keep away from the unit and have the unit to burn 20
minutes for the first time use.
Always ensure that lava rocks/pumice stones/lava glass
are completely dry before use. Failure to do so will cause
them to crack or pop.
Operation
Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor area. Connect
the propane gas tank to the regulator and turn the valve on the unit to the 'OFF' position. Brush a soap and water
mixture on all connections. Turn the gas supply on; if bubbles occur on any connection there may be a leak. If you
smell gas or a leak is discovered turn the gas valve off, disconnect propane gas tank and do not use the appliance
until the leak is repaired.
Do not use the heating unit without inspecting the gas hose. If there are signs of
wear or abrasion you must replace the hose (if applicable). Pumice stones/lava
rocks/lava glass could pop up and strike somebody's face during the process
of lighting this unit; stand away from the unit for the first 20 minutes after igniting.
Flame height should be a yellow/blue color between 2-10 inches in height.
Wait 50 minutes after extinguishing fame prior to placing a lid (if applicable) or
protective cover on heating item.
To light
1. Make sure the control knob (I) is in the "OFF" position.
2. Remove door (C) and slowly open the valve on the propane gas tank by turning the knob counterclockwise.
3. Replace the door (C) on the body (B).
4. Push and hold in the electronic igniter (J) to create sparks within the electrode, continue to hold.
5. Push in the control knob (l) and turn to the "LOW" position. Keep holding down the control knob (I) to allow gas
to flow for 15 seconds.
6. If ignition doesn't occur within a few seconds, release the control knob ( I) and rotate to the ''OFF'' position. Wait
for 5 minutes for gas to clear and then repeat the above lighting instructions.
7. Once the fire product is lit, the flame intensity may be controlled by turning the control knob (I) between the
"LOW" and "HIGHT" positions.
To extinguish
1. Tum control knob (I) clockwise to the "LOW" position; let the knob pop up and continue turning thecontrol knob
(I) to the "OFF" position.
2. Close the cylinder valve on the propane gas tank if you don't intend to use it for a long time.
3330-A Marathon Ct Charleston, SC 29418
Visit Us: Camplux.com
www.camplux.com
A
1(844) 538-7475
E
support@camplux.com
Publicidad
