Publicidad
Idiomas disponibles
Idiomas disponibles
to hand before raising the vehicle. If you do not
use axle stands, the vehicle may tip over and
cause a risk to life.
Follow these steps:
Ensure that the support plate
lowered and the extension screw
pletely screwed in before you put away the
vehicle jack.
Place the hydraulic vehicle jack in the desired
position. In choosing the position, observe
the provisions of the owner's manual for
your vehicle.
If necessary screw out the extending screw
until it comes into contact with the un-
2
derside of the vehicle (Fig. B).
Connect the rod
7
to extend the lifting handle.
CAUTION! RISK OF SHEAR-
ING AND CRUSHING IN-
JURY! Keep your fingers away
from the area of the lifting handle socket
while pumping. Failure to observe this advice
may result in shearing and crushing injury.
Guide the end of the lifting handle
the lifting handle socket
vehicle up to the desired height (Fig. D).
Place the axle stands under the designated
jacking points under the vehicle.
Relieve the load from the vehicle jack by
placing the rod
7
on to the release valve
rod
slightly anticlockwise before turning
7
it back immediately. The support plate
drops slightly and the vehicle is held on the
axle stands.
Lowering the vehicle
Q
DANGER TO LIFE! Check that no person
or object is under the vehicle before you
lower it.
CAUTION! Lower the vehicle slowly, other-
wise there is the danger of injury and damage
to the product or to the vehicle.
is fully
1
is com-
2
to the lifting handle
6
3
into
6
and pump the
3
with the oval opening
, then turning the
5
1
First raise the vehicle slightly in order to be
able to remove the axle stands. Proceed as
described in the section on „Raising the
vehicle".
Remove the axle stands.
Place the rod
with oval opening on to the
7
release valve
and turn the rod slowly
5
anticlockwise (Fig. C). The vehicle is lowered
slowly.
Note: The more quickly the rod
turned anticlockwise, the faster the vehicle
is lowered. Therefore you should proceed
very cautiously at first in order to get a feel-
ing for the correct speed.
Lower the support plate
longer loaded. Then pull the vehicle jack
out from under the vehicle. Press down on
the support plate
Close the release valve
rod
on the release valve
7
Take the rod
off the release valve
7
If it is extended, screw the extension screw
back down into the jack body.
2
If the jack can no longer be lowered as de-
sired, secure the vehicle at all costs using
safety stands to prevent it unintentionally
being lowered. Procure another jack to
hoist the vehicle as far up as possible for
you to be able to safely remove the defec-
tive jack. Seek professional help if you are
uncertain.
Cleaning and Care
Q
L iberally grease all external moving parts.
C lean the hydraulic trolley jack using a
slightly oily cloth.
N ever use harsh or corrosive cleaning agents.
is
7
until it is no
1
until it is fully lowered.
1
by turning the
5
clockwise.
5
.
5
GB/IE
15
Publicidad
