Show; Recording Dmx Signal - Work Pro W LED Player 100 Instrucciones De Usuario

EN
Operation Guide

5. Show

5.1 Recording DMX Signal

Fn /Record
SHOW
There are 3 record modes for user selection available in Manual mode, Auto
mode and Semi-Auto mode.
In Auto mode,
signal of "non-zero" will be recorded to the device automatically. While
detected the next signal of "all zero", all the indicators flash once, the
recording is complete.
In SEMI-AUTO mode, while detected an initializing signal of "all zero", the
rest signal of "non-zero" will be recorded to the device automatically. If you
want to stop recording, press SHOW button. While detected the next signal
of "all zero", all the indicators flash once, the recording is complete.
In MANUAL mode, while the device goes into the state of ready to record, manually
press the SHOW button and the device is processing record. Then press the same
SHOW button again to finish recording, all the indicators flash once, the recording
is complete and the device record all the DMX signal it receives.
Every SHOW is allowed to record up to 16 DMX segments. The total
time of record can exceed 1000 minutes.
LED Player 100
1. To enable
down the "Fn/Record" button for about 5 seconds
until the LED indicator next to the "Fn/Record"
button is lit.
2. Press one of Show1-8 buttons to which you
want to record DMX signal.
3. Press the same Show button to choose record
mode. Then press "Fn/Record" button to enable
the record mode. In the process of recording, you
can press "Fn/Record" button to stop recording.
while detected an initializing signal of "all zero", the rest
User Manual/Instrucciones de Usuario
Programmable state, press and hold
PAG. 17