Steinberg Systems SBS-MR-1500/H Manual De Instrucciones página 18

3.2. Preparation for operation
POSITIONING OF THE UNIT
The ambient temperature must not exceed 40°C and ambient humidity should not
exceed 80%. Place the unit in a way that ensures good air circulation. Maintain a
minimum clearance of 10 cm from any wall of the unit. Keep the unit away from any
hot surfaces. Always operate the unit on a level, stable, clean, fireproof and dry
surface and out of the reach of children and persons of impaired mental, sensory
and intellectual functions. Place the unit in such a way that the mains plug can be
reached at any time. Ensure that the power supply to the unit corresponds to that
specified on the identification plate!
3.3. Working with the unit
CAUTION!
are complete and as expected! In case of discrepancies, contact the supplier
immediately!
DEFINING THE OPERATION OF THE DEVICE
a) Plug the machine into a power outlet.
Turn on the unit by setting the power switch to the "I" position:
b)
SBS-MR-1500/H - rear of the unit,
SBS-MR-1500 - side of the device.
c) Set the
Turn the knob clockwise to increase the rpm,
Turn the knob to the left to decrease rpm.
d) The selected device speed will be displayed at the bottom of the LCD, with the
message "SET" (1 - see figure).
e) Once defined, the value of the device speed will be saved.
f) To start the appliance, press the speed control knob.
Before working on the device, make sure that all components
desired speed of the device with the knob.