Publicidad
Idiomas disponibles
Idiomas disponibles
PEDAL COMMANDER
Worlds Most Advanced
Throttle Controller System
The minus (-) button will light a red LED and
decrease the sensitivity from -1 to -4.
The plus (+) button will light a green LED and
increase the sensitivity from +1 to +4.
Note: We recommend coming to a complete stop
before changing modes or sensitivity levels. The
Vehicle does not need to be in "Park".
Pedal Commander offers 4 program selections.
Eco, City, Sport, Sport ( + ). Each mode has 9
different sensitivity levels (up to 36 levels in total)
and can be changed by pressing the program
button.
STOCK: When all the Pedal Commander lights
are off, your vehicle is operating at stock throttle
response.
Eco Mode is accessed by holding the program
button for 3 seconds.
ECO MODE: Used for fuel savings, smoother
driving,
better
traction
conditions and can also be used for off-road
purposes.
*Pedal Commander will not be active while the
cruise control system is engaged.
CITY MODE: Perfect for daily driving.
SPORT MODE: Spirited driving.
SPORT(+) MODE: Great for racing at the track.
2
in
heavy
weather
Installation Instructions
1 -Turn off ignition
2- If your vehicle has keyless entry, keep the key
fob at least 35 ft. (10m) away from the vehicle
(the signal can give power for your system). Wait
5 minutes to give everything time to power down.
3- Locate your accelerator pedal assembly plug
connection.
4- Remove the plug on your gas pedal.
5- Plug male and female connectors into their
coordinating plugs on the gas pedal. Make sure
the both plugs "click" into place.
6- Make sure cables are tucked in place so they
do not effect or endanger your driving.
7- Route the Pedal Commander to where you
can access easily.
8- Use the included alcohol wipe to clean the
area where you would like to mount the bracket.
9- Apply velcro to the bracket and cleaned area.
10- Put the Pedal Commander into bracket and
you're done!
If you unplug the gas pedal too soon, you will
receive a check engine light because the vehicles
computer still has power and has detected a
sensor unplugged.
If you are visiting a dealership[ for routine
maintenance, you do not need to unplug Pedal
Commander, just turn off and tuck it out of sight.
If you are visiting a dealership for an issue
or
warranty
repair,
COMMANDER FIRST. Pedal Commander will
REMOVE
THE
PEDAL
3
Publicidad
