Descargar Imprimir esta página

Kinderkraft SMARTFUN Manual De Instrucciones página 22

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
Non-rechargeable batteries are not to be recharged. Different types of batteries or new and
used batteries are not to be mixed. Check polarity when inserting batteries. Remove empty
batteries from the product. Do not short-circuit power poles. The batteries can be charged only
under adult supervision. Rechargeable batteries are to be removed from the toy before being
charged.
Technical data
Battery operated: 2 pcs. x AA 1,5 V (not included)
Product description
Item No
A
B
C
D
E
F
G
H
1
J
Baby bouncer assembly:
To assembly the baby bouncer frame place the runners (A) in a standing position as shown in
Figure 1 and connect them with the fastening tube (E), inserting the runners in the holes and
securing with the plastic caps on both sides (FIGS. 2A and 2B). NOTE! The on-rocker rubber pads
should be fitted into the plastic cap slots in such a way that the flat rubber base faced the floor.
Then place the seat frame (D) on the base (FIG. 3). Slide the seat bar downwardly as far as
allowed by the structure of the base frame (FIG. 3A) and secure with the fixing clamp (FIG. 3B).
Make sure that the notch on the playing mechanism faces downwards (FIG. 4). The next step is
the installation of the backrest frame (B). For this purpose connect the backrest tubes until the
locking button is fixed in the designated slot on the frame (FIGS. 5A and 5B). Pull the cover on
the backrest frame (FIG. 6). Put the bottom part of the cover on the seat frame (FIG. 6A) and
place the tubes in the cover on the baby bouncer frame on both sides (FIG. 6B). Make sure that
all parts have been properly secured and the structure is stable. A properly placed cover is
presented in Figure 7. The bouncer is ready for placing a child in it. The child should be secured
using the crotch and lap straps fastened in the buckle (FIG. 8). Hang the toys on the bar (FIG. 9),
and then install the bar on the baby bouncer frame using the clamps (FIGS. 9A). Insert the
batteries as described below and slide the playing mechanism (J) in the hole in the cover making
sure that the metal frame is tucked in the recesses of the mechanism (FIG. 10).
Fitting or replacing batteries:
To fit or replace batteries remove the cover of the playing mechanism in the baby bouncer, then
using a screwdriver remove the locking flap and replace the batteries ensuring proper polarity.
Item Description
Rockers
Backrest frame
Cover
Seat frame
Runner fixing tube
Toy bar
Toy hooks
Mirror
Booklet
Playing mechanism
22
Quantity
2
2
1
1
1
1
2
1
1
1

Publicidad

loading