Installation; General Information; Transport, Handling, Unpacking, Location - Fagor Slim Line Manual De Instrucciones

INSTALLATION

2.1 General information

2.2 Transport, handling, unpacking, location.

2.3 Intended use and restrictions.
2.4 Manufacturer's identification label description.
2.5 Installation and assembly.
2.6 Connections (electric, gas, water)
2.7 Tapping Instructions
2.8 Install the air channels and draft towers
2.1
General information
You can find in you equipment the following symbols, or stickers to identify some
type of warnings or useful information about your equipment.
2.2
Transport, handling, unpacking, location
Upon receiving your new FAGOR BAR, check the package and the machine for any
damages that may have occurred during transportation. Visually inspect the
exterior of the package, if damaged, open and inspect the contents with the
carrier. Any damage should be noted and reported on the delivering carrier's
receipt.
In the event that the exterior is not damaged, yet upon opening, there is concealed
damage to the equipment notify the carrier immediately. Notification should be
made verbally as well as in written form. Request an inspection by the shipping
company of the damaged equipment.
Retain all crating material until inspection has been made. Contact the dealer
through which you purchased the unit.
Check the compressor compartment housing and visually inspect the refrigeration
package. Be sure
lines are secure and base is still intact.
Manual Instructions
2
fagorindustrial.com