LOTRONIC ROADY-FL Manual De Uso página 6

UHF MICROPHONE
1. Microphone element
2. Light ring: 2 operating modes: Steady on or flashing when somebody talks into the micro-
phone
3. LED display: shows the operating frequency and state
4. Turn On/Off: Long press to tun on/off, short press to change the light mode
5. Transmitting antenna: Do not cover the antenna during operation otherwise the transmis-
sion distance will be reduced.
6. USB-C connector to charge the built-in battery via the supplied USB lead
OPERATION OF THE MICROPHONE
Make sure that the microphone is fully charged prior to using it. Switch on the microphone.
It will connect automatically to the ROADY-FL. If you have bought a second microphone (item
code: ROADY-FL-MIC), switch on the second microphone. It will also connect automatically to the
ROADY-FL without any further settings. Switch the microphone off after use.
BLUETOOTH CONNECTION
The unit switches automatically into pairing mode after power on. The digital screen flashes
slowly, the Bluetooth icon lights up.
Select ROADY in the list of found devices and connect it. When connected, the digital screen is
always on and displays "BL", the Bluetooth icon lights up.
Bluetooth disconnection: Disconnect the device on the phone/devices, or hold the - & + but-
tons simultaneously to disconnect. When disconnected, the digital screen flashes slowly, the Bluetooth icon lights up.
Reconnection: The unit automatically connects with the device, to which it had been connected before. When connec-
ted, the digital screen is always on and displays "BL", the Bluetooth icon lights up.
TWS CONNECTION FOR SPEAKERS
Make sure that both speakers are disconnected from any Bluetooth device. In Bluetooth pairing mode, hold the Play/
Pause button for 2-3 seconds to enter TWS pairing mode. The digital screen flashes quickly and pairs another speaker
automatically. When TWS connected, the master speaker's digital screen flashes slowly, the slave speaker's digital
screen is always on.
CONNECT WITH THE TWS CONNECTED SPEAKER
When two speakers are connected in TWS, select the Bluetooth name (will display only one Bluetooth name) on the
phone and connect it. When connected, the digital screen is always on and displays "BL", the Bluetooth icon lights up.
TWS disconnection: When no phone is connected with two TWS connected speakers, hold the - & + button simul-
taneously to disconnect the TWS.
When a phone is connected with two TWS connected speakers, hold the - & + button simultaneously to disconnect the
Bluetooth connection first, then hold the - & + button again to disconnect the TWS. When disconnected, two speakers
will return to Bluetooth pairing mode, the digital screen flashes slowly.
RECORDING
The recording function works only with a TF card or USB flash drive inserted. Press the Record button to start recording.
The recording function can support recording accompaniment and microphone sound synchronously. The "REC" icon
flashes on the digital screen.
Play recorded files: Hold the REC PLAY button (31) on the remote control to play the recorded files.
Delete recorded files: When playing a recorded file, hold the Play button to delete the playing file. (Only works du-
ring the play of the recorded file)
SWITCH THE PLAY MODE
Press the Power button (10) on the unit or the MODE button (33) on the remote control to switch mode among Bluetoo-
th, USB, TF, AUX.
LOW BATTERY ALERT
The battery power is at 20%-30%. The digital screen displays the battery icon.
Low power shutdown: The battery power is at 10%. The digital screen displays the battery icon. Reset: Press the
Reset button (between the wired microphone and guitar ports).
6
MANUAL - ROADY-FL
1
2
3
4
5
6