Adler europe AD 8082 Manual De Uso página 4

19. Do not expose the icemaker to direct sunlight, rain, snow, excessive moisture, etc.
20.Keep space around the ventilation openings. Covering them will reduce the cooling
capacity and may damage the icemaker.
21. CAUTION: FILL ONLY WITH DRINKING WATER.
22. The appliance is for domestic use only.
23. WARNING: Protect the cooling system from damage
24. WARNING: This equipment contains high pressure refrigerant. Do not modify the
device. The device may only be serviced by a qualified - authorized service center.
25. WARNING: When positioning the equipment, make sure that the power cord is not
pinched or damaged.
26. WARNING: Do not stack extension cords or portable power adapters on the back of
this apparatus.
CAUTION: RISK OF FIRE
Installation:
1. Place the icemaker on a level, level surface.
2. Pour water up to the line marked inside the machine.
3. Activate the device as a contact.
Device Description ( Img. 1 ) Ice cube maker
1. Cover 2. Control Panel
4. Ice Full sensor 5. Ice Scoop
7. Air outlet 8. Maximum Water Level: --------------△-------------- (Not Shown on the image)
Control Panel Description (Img. 2)
A. Ice size selection indicator: Small or Large
B. Power indicator
C. Ice Full indicator
D. Add water indicator
E. On / Off button
F. Ice size selection button
Before first use:
1. Remove all packing materials from the outside and inside of the device.
2. Clean the body and insides of the device with an soft cloth using an light cleaning solution of water and dish cleaning soap.
3. Dry with an nonabrasive paper towel or an dry cotton towel.
4. Place the device in an place where it is not in direct sunlight, away from any heat sources like for example: Heat stove, electric cooker.
5. Make sure the device has enough space around the air intake and exhaust and it is standing on an flat and even surface. Each side of
the device should have at least 15 cm of free space around it.
6. Wait around 1 hour after moving for the cooling gas inside to settle. If not done so, the device might be damaged or broken.
Usage of the device:
1. Check if the water drain cap is in place and plugged in correctly.
2. Add water into the device. (Please use only clean drinking water.) Do not exceed the Maximum water level line (8) shown inside the
device.
3. Place the ice basket (6) inside of the device.
4. Plug in the device into the mains power.
5. The device will enter standby mode. It is indicated by the blinking power indicator (B).
6. Turn on the device by pressing the On / Off button (E).
7. The device will turn on and the Power indicator button (B) will stay lit and the ice selection indicator will also stay lit showing the
current ice cube selection, either small or big. (It is recommended to use the Small size of the ice cubes if the ambient temperature is
above 15 ° C / 60 ° F to avoid the ice cubes sticking together.)
8. You can change the size of the ice cube size by pressing the Ice size selection button (F).
The device will produce ice cubes until it runs out of water. Please take out the produced ice cubes after each use. Do not leave the ice
cubes in the basket. They will melt and be made into ice cubes again and again.
9. Use the attached Ice scoop (5) to take the finished ice cubes out of the basket.
10. When the device has used up all the water to produce ice cubes the Add Water indicator (D) will turn on. Remove all remaining ice
cubes and add water into the device.
11. After finishing work with the device. Please remove the water drain cap (3) and move the device so that all of the remaining water
drains down it. Then please use an paper towel to dry the devices inside so no water remains.
12. Replace the water drain cap.
3. Water Drain Cap
6. Ice basket
4