Techno Line COST MANAGER Manual De Instrucciones página 11

Functions
Cost Manager is an electronic device dual tariff cost display, which can
measure energy and cost of household appliances, and help users reduce
the power bill and carbon emissions.
Operation steps
Pull out the safety strip from the battery compartment to have the button cell
batteries connect within the COST MANAGER and give it back-up power to
safe the settings.
Secondly connect the electric appliances with COST MANAGER and
connect it to the household power supply. COST MANAGER is now ready
and starts in display mode with clock display.
Replacing the batteries
If batteries run low on power and need replacing, disconnect the COST
MANAGER from electric appliances and the household power supply.
Unscrew the screws that hold down the battery compartment cover and
remove the cover. Replace 2 x LR44 button cell batteries with fresh
batteries, close the battery compartment cover again and tighten the
screws. Connect the COST MANAGER from electric appliances and the
household power supply again.
Display mode
After powering up, the LCD screen of the COST MANAGER will show all it's
contents for 3 seconds and then start to display the time, cost and energy.
Note:
After 10 seconds without operation the LCD will turn off to save energy, but
the operations will still be active in the background.
Clock display
The upper row displays (Clock) icon and 0:00. Within the first 60
minutes (0:00 to 0:59), the first number shows the minutes and the following
number shows the seconds. After the first 60 minutes (1:00 to 23:59) the
time is displaying hours as first number and minute as second number.
Clock setting
Press and hold the "CLOCK" button for 3 seconds and the
(Clock) icon
will flash, while the COST MANAGER enters time setting mode. The
EN2