Techno Line COST MANAGER Manual De Instrucciones página 14

Overload alarm setting watts (range: 0.000-9999 W ).

Press "ENERGY" button more than three seconds, it will enter into
"OVERLOAD" watts setting, the "OVERLOAD" on the screen will blink,
press the "SET" button to select the point and then press the "UP"
button set the selected point. Press "ENERGY" button to save and exit
the setting mode and return to initial LCD displayed mode.
Notes:

OVERLOAD is automatically quit after no further usage of buttons.

When current load power exceed the overload parameter which was
set before, the "OVERLOAD" will keep twinkling, it means this is a
safety danger, which is the initial set parameter of 3680W.
General information

Symbol of "COST" which is on the upper left corner of second row, and
"ENERGY" which is on the upper left corner of third row always display
on LCD.

Outside of settings, the "UP" button has no operation.

When in setting mode, press and hold the "UP" button to quickly set
the setting value.
Troubleshooting

Check whether the connected power supply is in use.

Check if the batteries in the COST MANAGER are correctly inserted.

When the display is abnormal or shows no reaction, press the
"RESET" button of COST MANAGER for recovery.
Declaration of conformity
Hereby, Technotrade declares that this product COST MANAGER is in
compliance with the essential requirements and other relevant provisions of
Directive 2014/30/EU and ROHS 2011/65/EC. The original EU declaration
of conformity may be found at: www.technoline.de/doc/4029665000886
Specifications
Normal operation voltage: 230V/50Hz；
Load current: MAX: 16A
Voltage working range: 175V～276V
Timing display range: 0 second～9999 days
Power display range: 0.000～9999W
EN5