Dometic PJS 1000 Instrucciones De Uso página 17

PJS1000
I
NOTE
• The jump starter can jump-start up to 30 times, depending on the displacement and
vehicle engine.
• Jump-starting may not work properly for vehicles that require remote battery jumper
locations (e.g., battery is in the trunk or other location). Refer to the operating man-
ual of your vehicle.
Observe the following instructions before jump-starting vehicles:
• Put the vehicle in parking position. Ensure that vehicles with manual transmission are in neutral and the hand-
brake is engaged.
• Ensure that the jump starter is at least 50 % charged. If the state of charge is below 50 %, the jump starter may
not be able to jump start a vehicle.
• Ensure that the plug (EC5) is firmly seated in the jump-starting output on the jump starter.
• Disconnect all digital mobile devices before connecting the battery clamps.
Observe the following instructions after jump-starting vehicles:
• Disconnect the battery clamps within 30 seconds in reverse order (see chapter "Disconnecting the battery
clamps (fig. 7, page 7)" on page 17).
• Switch on electrical consumers, e.g., ventilation to protect the on-board electronics.
• Keep the engine running or drive the vehicle for at least 30 minutes to ensure that the battery can sufficiently
recharge.
Connecting the battery clamps (fig. 6, page 6)
1. Connect the red (rd) battery clamp to the positive terminal of the starting battery.
2. Connect the black (bk) battery clamp to ground (chassis).
I
NOTE
• If specified, observe the information on suitable ground points in the operating
manual of the vehicle.
• Suitable ground points are stable unpainted metal parts in the engine compart-
ment, e.g., the engine block.
✔ The red and green LED of the battery clamps flash 1 – 3 seconds. Afterwards the green LED of the battery clamp
lights up continuously.
Disconnecting the battery clamps (fig. 7, page 7)
1. Disconnect the black (bk) battery clamp.
2. Disconnect the red (rd) battery clamp.
8.7 Charging via USB
I
NOTE
• Charging of digital mobile devices is not possible while the jump starter is being
charged.
• Two digital mobile devices can be charged at the same time by using both USB out-
puts.
EN
Operation
17