FAR KJ 60 Instrucciones De Uso página 12

TOOL IDENTIFICATION
The riveting tool KJ 60 is identified from a marking that shows
company name and address of manufacturer, designation of
the tool, CE. Always refer to the information on the riveting tool
when requesting technical service.
Company name and
address
Serial number
GENERAL NOTES AND USE
The tool can be employed only for blind rivet nuts with thread
of M3 ÷ M8 diameter ( Inox M8 excluded ).
The KJ 60 oil pneumatic system assures more power than
the pneumatic system used for other models. That means
a reduction in the problems due to the wear and tear of the
components, therefore, there will be an increase in reliability.
The technicai solutions adopted reduce the dimensions and the
weight of the tooi which, for these reasons, make it very handy.
The possibilities of leakage from the oil-dynamic system, are
eliminated by some sealed gaskets, which solve this problem.
12
Designation of the tool
KJ 60
750313 - KJ60 – rev 24 - ( 09-2022)
GB
MAIN COMPONENTS
A) .................................................................Threaded tie rod
B) ...................................................................................Head
C) ..................................................... Ring nut clamping head
D) ...............................................Tensile strength pushbutton
E) .....................................................Unscrewing pushbutton
F) ................................ Insertion Pin Hole Dechucking clutch
G) ..................................................Regulation stroke ring nut
H) .......................................................... Balancer connection
I) ..................................................................
L) .......................................................................Oil tank plug
M) .............................................. Compressed air connection
N) ............................................................... Protection bottom
A
B
C
D
E
M
N
TECHNICAL DATA
• Working pressure ......................................................6 BAR
• Min. int. diam. of the compressed air
feeding hose ....................................... min. diam = 8 mm
• Air consumption per cycle ............................................9
• Max power .................................................6 BAR -13656 N
• Weight .................................................................. 2,200 Kg
• Working temperature ...........................................-5°/+50°C
• Root mean square in total acceleration frequency (Ac)
to which the arms are subjected. .........................
• A-weighted emission sound pressure level ............. 70 dBA
• Peak C-weighted instantaneous sound pressure <130 dBC
• A-weighted sound power ........................................ 82 dBA
AIR FEED
The air feed must be free from foreign bodies and humidity in
order to protect the tool from premature wear and tear
of the components in movement, therefore we suggest to use
a lubrificator group for compressed air.
Pneumatic motor
L
Ø 109
< 2.5
KJ 60
Nl
m/s
2