Master Trimmers Trim Filter Manual De Uso página 11

Placement
Master Products machines must be placed on a flat surface without irregularities on the ground. The machines are only
suitable for indoor use and under no circumstances should be exposed to moisture or water. The electrical system must
always be kept dry.
Operation
The Trim Filter is designed for working with all types of herbaceous and semi-woody plants. Other types of materials
must not be processed.
Start up
Assembling the aspirator
In order to assemble the Trim Filter, the following tools are required: Allen wrench no. 4, Allen wrench no. 5 and fixed wrench
no. 13.
Joint of the aspirator (O) and fasten it with the help of
1
the bolts (P) and the washers (M).
Fit one of the silicone gaskets (I) to the cyclonic filter
3
(B) in the base of the main component (A) and place it
on the upper support part, as shown in the figure.
Then fit the other silicone gasket (I) to the upper
support part of the assembly of the previous step and
place this in the lower support part. Finally fasten both
parts together with the bolts (L) and washers (M).
IMPORTANT: the side entry of the cyclone must be
opposite the output from the aspirator.
Fit the container cover (G) with one of the silicone
2
gaskets (I) and the container cover collar (H). Fit the
bolts (J) and washers (M) to riveted nuts.
Attach the air hose support (C) to the Trim Filter with
4
the help of the bolts (K) and washers (M). As shown in
the image.
11