Descargar Imprimir esta página

Samoa METER Manual De Instrucciones página 15

Publicidad

E5
Mounting the extension on the METER
Three di erent types of extensions can
be installed on the nozzle METER:
• ADJUSTABLE extension;
• RIGID extension;
• FLEXIBLE extension.
All of them are equipped with an
automatic dripless valve.
All extensions are equipped with a rigid
ending part (external ? 12 mm, 3/8"G
nut) suitable for being easily connected
to the METER without using any sealant.
• Remove the plug from outlet A (3/8"G).
• Make sure that gasket B on the
connector is in its seat.
• Lubricate the gasket and its seat.
• Tighten end D on METER by means of
two wrenches;
while the rst one on outlet A blocks the
METER, the second one tightens nut C
of end D.
Before locking nut C orientate valve E.
E6
Mounting the METER
• Fit the rubber cover of the swivel into
the exible hose, in the direction
indicated in the gure, making it slide
over the male thread of the hose.
• Apply a thread sealant to the male
threads of the exible hose.
• Tighten the swivel completely by
means of two wrenches.
• Make the rubber cover slide towards
the valve until it goes into the specially
provided seat, located on the swivel.
E
D
C
B
A
Warning
An improper tightening of the
extension may cause it to become
loose thus endangering persons or
things.
Tighten the ring nut with a torque
wrench setting at 3.5 Kgm.
17

Publicidad

loading