Gamma+ BARBERHOOD CYBORG Manual Del Uso página 15

The appliance can be charged by connecting the feeder directly to the appliance or
by connecting it via the base I (fig. 1).
1) Direct connection: connect the feeder connector F (fig. 1) to the port at the
bottom of the appliance C (fig. 1).
2) Connection through base: insert the appliance into the base H (fig. 1) and the
feeder F (fig. 1) into the port at the bottom of the base.
3) In both cases, connect the other end of the feeder to the mains power supply.
4) While charging, the LED will remain on and turn off once the appliance is fully
charged.
Fully charge the appliance at least once a year.
USE
ATTENTION! Do not use the appliance if the blades of the heads A (fig.1)
are damaged or if the blade block is not working correctly.
Do not use the appliance on wet hair.
TURNING THE APPLIANCE ON AND OFF
Turning on and off
• Press switch B (fig. 1).
USEFUL TIPS FOR CUTTING
• Wash the hair as usual, dry and brush it in the direction of growth to untangle
any knots.
• After drying, do not use hairspray, mousse or gel.
• Start with the larger size distance comb G (fig. 1), and gradually reduce the size
until you get the desired result.
• For best results, use the appliance against the direction of hair growth.
• If hair starts to clog the adjustable guide comb, remove the comb from the
appliance (see par. "Removing the adjustable guide comb") and clean away
the hair (blow and/or brush it out).
USING THE APPLIANCE
Turn off the appliance before changing or inserting any accessories.
Cutting length adjustment
The cutting length can be adjusted using the special lever (fig. 2).
Cutting adjustment lever
This product has the possibility to customise the cutting adjustment lever. The
product has been assembled with the adjustment lever suitable for use with the right
hand D-L (fig.1). It is possible to remove the D-L lever from the left side and assemble
the D-R lever from the right side (fig.1) for use with the left hand.
The operation involves the removal of screw N (fig.2) from the D-L lever using the
screwdriver supplied E (fig.1). Once the D-L lever has been removed, assemble the
15