Steren BAF-0880 Manual De Instrucciones página 15

Bafle profesional con amplificador
Ocultar thumbs Ver también para BAF-0880:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTRUCTIONS
Make all initial connections with the power switches OFF on all equipments. Make sure volume level
are all the way down, you can adjust it later.
1. Connect the power cable to the electric outlet and connect the other end of the power cable to
the speaker.
2. Connect a microphone to the input jack labeled MIC IN through the 6.3 mm plug or cannon plug.
3. Use the RCA line in input jacks in order to connect a CD, MP3, DVD, or other type of audio device.
4. Power all the devices on. A green LED indicator light will illuminate indicating that the speaker is
powered on.
5. Adjust the volume levels of the connected devices (CD, MP3, etc.) as well as the line in level on
the speaker. Also adjust the Bass and treble levels in order to equalize the sound.
6. The red LED indicator light will illuminate if an overcharge is detected. This occurs in order to
protect your speaker. The volume levels should be reduced in order to prevent serious damage to
the speaker.
PLACEMENT
These speakers have been designed for placing on the ground, on a table or a speaker tripod. We
remind you that the tripod BAF-150 is compatible with this model.
Avoid placing the device in the corner of a room. Doing so will increase the low frequencies output
and may cause distortion in the sound.
Avoid placing the speaker in front of walls. This will also increase the output of low frequencies but
not as much as placing the speaker in a corner. However, if you need to emphasize low frequencies,
this is a good way to do so.
7

Publicidad

Tabla de contenido
loading

Tabla de contenido