Quality Craft MM906-42FBK Instrucciones De Montaje página 3

MANtEl ASSEMBlY:
CAUTION: Place a piece of cardboard or protective sheet on the floor in order to avoid
scratching the decorative surface of your mantel during assembly.
Please DO NOT fully tighten the KD screws until all panels are assembled.
Step 1: Attach 34 plastic connectors [X] to panels A, B, C, D, E, F, G, H, I, and L with 68
KD screws [W] (2 pcs KD screws for each connector). See Fig. A.
NOTE: If the KD screw(s) do not fit during assembly, loosen the 2 screws to adjust the
plastic connector until the panels/KD screws can be installed.
Step 2: Attach 8 shelf support pins [S] to panels C, D, E and F as shown in Fig. B.
Fig. A BAcK
Fig. B BAcK
Step 3: Attach right inner side panel [F] to base panel [B] with 1 KD screws.
See Fig. C.
Step 4: Attach middle front panel [H] to right inner side panel [F] as shown in Fig. D.
Step 5: Attach left inner side panel [E] to base panel [B] with 1 KD screws. See Fig. E.
3
Fig. C BAcK
Fig. D BAcK
Fig. E BAcK