monzana DBHD05 Manual De Instrucciones página 9

• To avoid danger in the event of damage to the appliance, please contact our Customer Service
team or send the appliance to one of our authorised service centres for repair; do not attempt
to replace parts without our authorisation.
• CAUTION! Read all safety information and instructions. Failure to follow the safety information
and instructions may cause electric shock, fire and/or serious injury.
• Ensure that water cannot get inside the appliance. Never immerse the appliance in water or
other liquids. Never expose it to rain.
• Do not use the appliance if the mains plug, mains cable or any other part of the appliance is
defective or damaged.
• Do not remove the mains plug from the socket by pulling on the mains cable.
• Never insert or remove the mains plug with wet hands.
• The plugs of electrical appliances must be compatible with the socket. Never change the plug.
Do not use any adaptor plugs with earthed electrical appliances. Original plugs and matching
sockets reduce the risk of electric shock.
INTENDED USE
The product is not a medical product and is not suitable for therapeutic purposes. Infants, small
children, disabled or heat-insensitive persons as well as animals must not be warmed using the
electric blanket. Use in dry, indoor rooms only. Use the product only for the purpose it is intended
for. The manufacturer accepts no liability for damage caused by improper use. Any modification
to the product may negatively impact safety, cause hazards and invalidate the warranty.
Only suitable for domestic use; not for commercial use.
UNPACKING INSTRUCTIONS
Open the box and remove the product.
After unpacking, please check the product for damage and to ensure it is complete. Subsequent
claims cannot be accepted.
OPERATION
The appliance must be switched to the lowest setting during long-term use or throughout the
whole night.
If the device is turned on at a higher temperature setting, the user may suffer skin burns or heat
stroke.
Insert the plug of the control element into the socket of the blanket until it clicks into place. Only
then connect the mains plug to the mains socket.
Switch the blanket on using the on/off switch (ON), the operating indicator lights up.
The blanket starts at heating level 5 out of 10, the switch-off time is set to 2 out of 10 hours.
Immediately after switching on, the red LED lights up and the digital display flashes for 5 seconds.
As long as the digits are flashing, you are in the setting mode for the heating level, which can be
set from 1 to 10 using the + and – buttons. Immediately afterwards, briefly press the Menu button,
the green LED lights up while the digital display is still flashing. You are now in the setting mode
for the switch-off time. It can be set from 1 to 10 hours using the + and – buttons.
After 5 seconds without pressing a button the digital display stops flashing and the heating process
starts as set.
9 www.DEUBAXXL.de