Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Attaching the Fan Blades (continued)
2
Attaching the blade assemblies
to the motor
□
Attach the blade assembly to the motor assembly (E) by
aligning the screw holes on the blade bracket (J) with the
screw holes on the bottom of the fan motor assembly (E).
Insert the screws (FF) and screw washers (EE) into the holes
on the blade bracket (J) and through the holes on the bottom
of the fan motor assembly (E), and tighten each screw to
secure the blade assembly.
□
Repeat this step for the remaining blade assemblies.
Assembly - Attaching the Light Kit
1
Installing the light kit pan
□
Remove one screw (LL) from the black bracket below the fan
motor assembly (E), and loosen but do not remove the other
two screws (QQ).
□
Push the light kit pan (F) up to the fan motor assembly (E) so
that the two loosened screw heads fit into the keyhole slots.
Turn the light kit pan (F) clockwise.
□
Carefully push the square wire connectors together. One from
the light kit pan (F) and one from the fan motor assembly (E).
□
Re-install the screw (LL) that was removed in the first step.
□
Make sure all the screws are firmly tightened.
2
Attaching the light kit fitter assembly
□
Remove one screw (OO) from the light kit pan (F), and loosen,
but do not remove the other two screws.
□
Connect the wires from the light kit fitter assembly (G) to
the wires from the fan motor assembly (E) by connecting the
molded adaptor plugs together. Carefully tuck all wires and
splices into the light kit pan (F).
□
Push the light kit fitter assembly (G) up to the light kit pan (F)
so that the two loosened screw heads fit into the keyhole slots.
Turn the light kit fitter assembly (G) clockwise to secure.
□
Re-install the screw (OO) that was removed in the first step.
□
Make sure all the screws are firmly tightened.
EE
FF
QQ
F
NN
OO
11
Please contact 1-855-HD-HAMPTON for further assistance.
E
J
K
L
LL
MM
G
HAMPTONBAY.COM
Publicidad
