Publicidad
Idiomas disponibles
Idiomas disponibles
Art. 580 / Art. 581 / Art. 584 / Art. 585
5
Assembling the shears or chainsaw and the handle
Disconnect the battery by pushing the two lateral buttons and
pulling upwards. Open the two locking-clips on the cover at the
top of the handle and connect the back of the shears or chain-
saw to the dedicated connector. Place the shears or chainsaw
inside the cover and close the locking clips.
Assembling the battery and the handle
Insert the battery into the dedicated slot at the bottom of the
handle by sliding it downwards until it clicks-in. To disconnect
the battery, push the two lateral buttons and pull upwards.
52
Magma telescopic handles
Assembly
Art. 580 / Art. 581 / Art. 584 / Art. 585
Magma telescopic handles
Removing the hand-protection
For an advanced safety, the control handle is equipped with a
protection for the hand of the operator, which can be removed.
To remove it unscrew the screw and pull it out from its slot.
Usage
Operation modes
Once you have inserted the cutting tool inside the the head of the handle and the battery in the
appropriate housing at the base, you are ready to start work. If you work with an electric shears,
the power button is accessible from a hole in the metal protective shell. Press the power button
and follow the operating instructions on the user manual of the cutting item.
If you work with an electric chainsaw, once it has been connected to the connectors in the shell
and the battery has been inserted, the chainsaw is ready for use according to the instructions in
the user manual for the cutting tool purchased.
For further information about the product, please contact info@stockergarden.com
5
6
53
Publicidad
