Publicidad
Idiomas disponibles
Idiomas disponibles
9
English
USA Balboa Control System Usage Instructions
*Three control systems are referable, please read through the corresponding system carefully before
operation.
1. GS523DZ Balboa Control System
GS523DZ (for three SPA massage pumps, with VL801D panel)
(1) Initial Start-up
Your spa will enter Priming Mode (Pr）when it is energized. During Priming Mode, press "Jets" button (s)
repeatedly and be sure all pumps are free of air. Priming Mode lasts for less than 5 minutes. Press "Warm" or
"Cool" to exit. After Priming Mode, the spa will run in Standard Mode (see Mode section).
The pump responsible for heating and filtration (pump 1 low-speed on non-circ system, or the circ pump on circ
systems) will be referred to simply as the pump. In multi-button sequences, if the buttons are pressed too quickly in
sequence, they may not register.
Pump is the abbreviation of those used for heating and filtering. In operation, if you press too quickly, it may be
unavailable.
(2) Temp control (80°F-104°/26.0°-40.0°C)
The last measured water temperature is constantly displayed. The water temperature displayed is current only
when the pump has been running for at least 2 minutes. To display the set temperature, press "Warm" or "Cool"
once. To change the set temperature, press a temperature button again before the display stops flashing. After
three seconds, the display will stop flashing and begin to display the current Spa temperature.
(3) Jets 1
Press "Jets l" to turn pump 1 on or off, and this will be stopped after 15 minutes.
this key is without control any function and pump, this key is excrescent or use it to extend other function if you
need（If the control system carries two masage punps only)
(4) Jets 2/ Jets 3/Blower(if equipped)
Press the corresponding button once to turn the device on or off. The device will be off after 15 minutes.
Publicidad
