Building From The Sd Card - Dremel 3D20 Idea Builder Instrucciones De Funcionamiento Y Seguridad

DM 2610035691 12-14_3D20 4/3/15 9:53 AM Page 29
1. Insert SD card containing your model into
the SD port located on the right side of
your Dremel 3D20. Your Dremel 3D20
comes with an SD card containing free
model files ready to be built. Additionally,
you can save new .G3Drem files to your
SD card from the accompanying Dremel
3D software.
2. Ensure an adequate amount of filament is
loaded (see page 25)
TIP: You can determine whether you have
enough filament to complete your object
before building by weighing the filament
and spool then subtracting the weight of
the empty spool. The Dremel 3D software
will display the approximate weight of each
model.
NOTE: You cannot edit model files directly
on the Dremel 3D20. Ensure that you are
building .G3Drem files when building
directly from SD card.

Building from the SD Card

3. Ensure build tape is applied and build
4. Tap "Build" on the touch screen, tap the
5. Tap on the model file you would like to
6. Your Dremel 3D20 will first align the
7. Once the object is finished building, your
8. Wait until the touch screen indicates that
To cancel your object during warm up or
building, tap the "STOP" button on touch
screen. The next screen will read, "Cancel
build now?" Tap the "Yes" to cancel or tap
"No" box to abort the cancel command. Wait
until the extruder and build platform
completely cools before reaching inside the
build area.
29
platform is leveled (see page 27).
SD card option, and use the up/down
arrows to scroll.
build.
extruder and build platform. Your Dremel
3D20 will then begin the heating process
which may take a few minutes. During the
heating process, the extruder will reach
the temperature required for proper
building with PLA. Once this temperature
is reached, your model will begin to build.
touch screen will display "Object Finished".
Tap the check box to confirm.
the extruder temperature is "COOL" to
remove you object. See section for
removing you object from the build
platform below for object removal
instructions.
CANCELLING YOUR OBJECT ON
DREMEL 3D20