Ryobi FVH56 Manual Del Operador página 5

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance. In Mexico, please call 01-800-843-1111.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Applying hot glue adhesive
WARNING:
Battery tools are always in operating condition. Make sure
the power button is off and remove the battery pack when
the product is not in use or when carrying at your side.
ASSEMBLY
WARNING:
Do not attempt to modify this product or create accesso-
ries or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 9.
WARNING:
To reduce the risk of injury, the glue pen should be con-
sidered to be HOT whenever the LED on the unit is illu-
minated. Following this rule will reduce the risk of burns,
fire, or serious personal injury.
To install:
 Unscrew and remove the battery cap.
 Insert the battery pack into the product as shown.
 Place the cap over the battery pack and push down until
the cap meets the threads at the end of the tool.
 Screw the cap on securely.
NOTE: Do not attempt to use this product if the battery
cap is not securely closed.
To remove:
 Unscrew and remove the battery cap.
 Remove the battery pack from the tool.
For complete charging instructions, see the operator's manual
for your battery pack.
LED LIGHT FUNCTIONS
See Figure 2, page 9.
When a charged battery pack is installed in the tool, the
LED light will indicate the status of the tool when the tool
is powered on.
TOOL STATUS
Ready for Use
Low Battery (5- 25%)
Low Battery (0- 5%)
5 — English
LED LIGHT SCENARIO
Heating
Flashing Red (3 Flashes)
Flashing Green
Solid Green
Solid Red