Oversteel KRYPTO Serie Manual De Usuario página 8

3. Stand Installation
EN
Keep the foam underneath the monitor before attaching the stand.
Open the package and take out the monitor with foam still
1
attached. Gently place it top-down on a desktop or table.
Make sure the monitor is laid on a flat surface before removing the stand.
8
Screws x1
Remove the foam covering the bottom of the monitor, then remove the adapter
3
from the back of monitor. Use two NO. 1 screws to fasten adapter onto the stem.
With the stand fully assembled, reattach it onto the back of monitor. Then remove
4
the remaining foam on monitor and stand it up on a flat, level desktop or table.
Press the button to remove the monitor from the bracket if mounting.
Take out the stem and base. Use the included
2
screwdriver and one screw to fasten base to the stem.
Stand Stem
Base
Adapter
Button
KRYPTO
GAMING MONITOR SERIES
Screws x2