Honeywell CS10XE Serie Manual De Instrucciones página 8

Enfriador de aire evaporativo portátil
Ocultar thumbs Ver también para CS10XE Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USE & OPERATION (CONTINUED)
CLEANING THE CARBON DUST FILTER* AND HONEYCOMB COOLING MEDIA
The appliance is supplied with a Carbon Dust Filter* and Honeycomb Cooling Media.
The Carbon Dust Filter* and Honeycomb Cooling Media are located inside the Rear Grill. See
Figure 1 for instructions on how to remove them from the unit for cleaning and maintenance.
Do not run the unit in COOL mode with stale water in the tank. You must empty the water tank
and refill with fresh water, especially if the tank has not been cleaned in a long time.
The cleaning frequency for the Honeycomb media depends on local air and water conditions.
In areas where the mineral content of water is high, mineral deposits may build up on the
Honeycomb Cooling Media and restrict air flow. Draining the water tank and refilling with fresh
water at least once a week will help reduce mineral deposits. If mineral deposits remain on the
Honeycomb Cooling Media, the media should be removed and washed under fresh water. The
media should be cleaned every two months or sooner, depending on your needs.
For best results allow the Honeycomb Cooling Media to dry after each use by turning off the cool
function 15 minutes before turning the unit off.
Removing the Carbon Dust Filter*/ Honeycomb Cooling Media:
1.
Remove all the screws from the Rear Grill of the Air
Cooler.
2.
Carefully pull out the rear grill from the cooler.
3.
Slide out the Carbon Dust Filter* and clean with
water.
4.
To release the Honeycomb Media, remove the
Honeycomb Frame screws and pull the Honeycomb
Frame out of the unit.
5.
Remove the screws on the base of the Honeycomb
Frame and slide out the Honeycomb Cooling
media. Replace or clean media with water and a
damp cloth as needed.
WARNING:
DO NOT operate the Air Cooler when the Rear Grill
is removed from the Air Cooler, or if there is a loose-
fitting Rear Grill. Doing so can cause serious injury or
dangerous electrical shock.
Figure 1:
*Applicable for models with Carbon Dust Filter only.
EN
7
Honeycomb
Carbon
Cooling Media
Dust
Filter
Screws
Honeycomb
Frame
Rear Grill

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido