Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly Instructions
STEP 1: Wheel Assembly
1. Attach the wheels (#4) to the wheel stand secure using flat washer Ø20 (#6), thin hex slotted nut
M20x1.5 (#8) and cotter pin Ø4x36 (#5). Install the axle cap (#7) on the end using rubber hammer.
NOTE: Use a black plastic bushing to fix the axle cap (#7) like below picture. Please cover the black
bushing onto the axle cap, and use rubber/wooden hammer knocking the end of the plastic bushing
and make the axle cap fixed on wheel.
STEP 2: Attach Tow Bar and Fender
1. Attach the tow bar (#2) to the hydraulic reservoir using hex bolt M12x35 (#35), flat washer Ø12 (#20)
and hex lock nut M12 (#25).
2. Attach fenders (#89 & #90) to the hydraulic reservoir using hex bolt M8x25 (#69), flat washer Ø8
(#37), lock washer Ø8 (#57) and hex lock nut M8 (#38). Attach rubber washer (#131) between fender
and hydraulic reservoir.
Publicidad
