Publicidad
Idiomas disponibles
Idiomas disponibles
3.2.
Preparing for use
The Automatic Hose Reel must be installed on a wall or ceiling before use. For
this purpose, the mounting grip must be fastened with screws to the selected
surface. It is recommended to mount the device at a height of min. 80 cm above
the floor.
3.3.
Device use
In order to unwind the pressure line, it is necessary to pull and unwind it until
•
the desired length is reached.
In the course of winding, it is necessary to hold the line end so that it will not
•
be damaged.
•
Do not pull the pressure line when it is fully unwound from the drum. This
may cause locking the retractor or damage of the line itself.
•
Before unwinding and winding the pressure line, it is necessary to always
make sure that the supplying and receiving devices have been unfastened.
3.4.
Cleaning and maintenance
•
Before starting to clean the device it is necessary to disconnect it from the
source of the compressed air supply.
Use cleaners without corrosive substances to clean each surface.
•
•
Dry all parts well after cleaning before the device is used again.
Store the unit in a dry, cool place, free from moisture and direct exposure to
•
sunlight.
Publicidad
