GadgetMonster GDM-1051 Manual Del Usuario página 9

Close the lid before putting the submarine into water.
Pull out the antenna on the remote control. Change the switch to
"on" on the remote control.
Put the submarine into the water.
Remote control
1.
2.
3.
4.
5.
1. Function LED
2. Rise / go up
3. Forward
4. Backward
5. Power switch (on/off)
6. Charge LED
7. Dive / go down
8. Turn left
9. Turn right
The function LED will turn on when you press any button.
Press forward (3.), to make the submarine go forward.
Press backward (4.), to make the submarine go backward.
Press right (9.) or left (8.) to make it turn right or left.
Press dive (7.) to make the submarine dive.
The submarine must be submerged in water for the commands to
work.
Troubleshooting
If the submarine is getting slow, it means it has low battery.
For clarification: The submarine needs to be filled with water in the
front and rear. But not on the inside.
1
6.
7.
8.
9.
9