Publicidad
Idiomas disponibles
Idiomas disponibles
When the defrosting process is complete, the unit will automatically return to
dehumidifying mode.
Automatic dehumidification
a) Check the current temperature and RH (relative humidity). Press "SET" once to
set the target humidity. Press "+" or "-" to set the humidity. The setup is
complete if no button is pressed for 5 seconds.
b) When the ambient humidity is 3% below the set relative humidity, the unit will
stop dehumidifying and the screen will flash "DEHUM".
c)
When the ambient humidity exceeds the set relative humidity by 3%, the unit
automatically starts dehumidifying.
d) Humidity setting range: 10-95%
Note: Once the target humidity is set to less than 30%, the device will constantly
dehumidify.
Timer functions
a) Time setting
Press the "SET" button twice. After the clock flashes on the LED panel, you can
set the current time. Press the "＋" button to set the hours and the "-" button
to set the minutes. The setup is complete if no button is pressed for 5 seconds.
b) Start-up timer setting (T ON)
Press the "SET" button three times to set the start timer. Press the "＋" button
to set the hours and the "-" button to set the minutes. When the unit is not
working and reaches the set time, it will start up automatically. The setup is
complete if no button is pressed for 5 seconds.
c)
End of run timer setting (T OFF)
Press the "SET" button four times to set the end of operation timer. Press the
"＋" button to set the hours and the "-" button to set the minutes. When the
unit is running and the set time is reached, the unit will automatically turn off.
The setup is complete if no button is pressed for 5 seconds.
d) Turn off the timer
Change the timer value to "00" to turn it off.
"CONTINUE" button
Press CONTINUE to put the device into continuous operation. The humidity setting will
be 10%, but the actual humidity cannot reach this value. It would result in uninterrupted
operation of the unit.
Publicidad
