Publicidad
Idiomas disponibles
Idiomas disponibles
3. TO REPLACE THE BRUSHES (SEE FIG.
D1-D3)
WARNING: Remove the plug from the
socket before carrying out any
adjustment, servicing or maintenance.
Unscrew the carbon brush cap with screwdriver.
Remove the carbon brush. Check the length of the brush
and replace if under 6mm. When brushes need replacement
always renew both brushes, even if one is still more than
6mm long.
NOTE: please call helpline to purchase new brushes.
Continuing to use the tool when carbon brushes need to be
replaced may cause permanent damage to the tool.
TROUBLESHOOTING
Problem
Device does not start
Device works with
interruptions
EN
Possible cause
Mains voltage is not present
Defective on/off switch
Worn carbon brushes
Defective motor
Damaged power cable
Internal loose connection
Defective on/off switch
MAINTENANCE
1. Store the tool, instruction manual and accessories in
a secure, dry place. In this way you will always have the
information ready.
2. Keep the tool's air vents unclogged and clean at all times.
3. Remove dust and dirt regularly. Cleaning is best done
with a rag or brush.
4. Never use caustic agents to clean plastic parts.
CAUTION: Do not use cleaning agents to
clean the plastic parts of the tool. A mild
detergent on a damp cloth is recommended.
Water must never come into contact with the
tool.
Fault correction
Check plug socket, cable, line, plug and fuse, where
appropriate, repair through electrical specialist
Repair through customer service
Check cable, replace it
Repair through customer service
13
Publicidad
