Publicidad
Idiomas disponibles
Idiomas disponibles
3.
4.
6.
lnstallation
You shall please notice that, if you do not follow the information of this Manual, the manufactory will not assume
any responsibility far the damages which will happen.
Befare operatlon of the refrlgerator
Befare using the refrigerator, you shall please check the fallowing
contents:
1. Check whether the inside of the refrigerator is dry, and
whethe the air could flow freely behind the refrigerator.
2. lnstall 2 plastic wedges, as shown in the figure. The plastic
wedges will provide a necessary distance belween the
refrigerator and the wall, in order to allow the circulation of air.
(The figure is only provided as an example, and it is possibly
not completely the same as your product.)
Clean the inside of the refrigerator according to the suggestions in the Chapter
•Maintenance and Cleaning•.
Open the refrigerator plug and insert it into a wall-type socket. When the door of the
freezing chamber is opened, relevant lamps inside it will tum on.
s. When the compressor is started, you will hear a sound. Even if the compressor does not
work, the sealed liquid and gas inside the refrigeration system will probably produce noises,
and this is normal.
You will probably feel that the temperatura at the front side of the refrigerator rises. This is
normal. These areas are designad to maintain warm state, in order to avoid condensation.
Electric Connection
Connect this product to a grounding socket protected by a fuse of proper capacity. lmportant
infarmation:
• The connection must meet national regulations.
• After installation, the plug of power cord must be within reach.
• The specified voltage must be equal to power voltage.
• Please do not use extension cable and multiple plugs for connection.
Damaged power cord must be replaced by an electrician who has corresponding
qualifications.
Do not operate this product befare it is properly repaired, or it will cause the danger of
electric shock!
11
V.3
Publicidad
