Taurus TASTY MULTIPOT Manual De Instrucciones página 13

- Press the "Cancel" button if you want to cancel
this function.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Let the appliance cool down before releasing
the pressure, especially when cooking liquid
foods such as soups.
- Once the appliance has completed the cooking
time, before opening the lid turn the pressure
release valve to the "OPEN" position in the
direction indicated on the label.
- To avoid scalds or injuries, keep your face and
hands away from the valve opening. Exercise
extreme caution when releasing the steam, the
escaping steam is very hot.
- Unplug the appliance from the mains.
- Once all pressure has been released and
steam stops coming out through the valve,
remove the lid by turning it clockwise.
- To avoid possible scalding, wear an oven mitt
when removing the lid.
- Wind up the mains cable and unplug it from the
appliance.
- Clean the appliance, following the instructions
in the corresponding section.
CARRY HANDLE/S:
- This appliance has side handles which facilitate
comfortable transport
SAFETY THERMAL PROTECTOR
- The appliance has a safety device, which
protects the appliance from overheating.
- If the appliance turns itself off and does not
switch itself on again, unplug it from the mains
supply and wait approximately 15 minutes
before reconnecting it. If it fails to switch on
again, take it to one of the authorised technical
assistance services.
CLEANING
- Unplug the appliance from the mains and let it
cool before performing any cleaning task.
- Clean the equipment using a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Do not immerse the appliance in water or any
other liquid, or place it under a running tap.
- It is advisable to clean the appliance after each
use and remove any food remains.
- Take out the removable pot and use soap and
water to wash it by hand.
- Carefully remove the inner cover and sealing
gasket from the lid and wash with warm soapy
water.
- To ensure optimum performance, the heating
plate and temperature sensor should be
cleaned after each use. Wipe with a damp cloth
and then dry thoroughly.
- To clean the steam release valve, gently pull on
valve to remove it. Make sure none of holes are
blocked and proceed to wash the valve.
- The following parts can be cleaned in hot
soapy water or in a dishwasher (using a gentle
wash program):
- Measuring jug
- Spoon
- Condensation collector
- Steamer basket
- Next, dry all the parts before fitting them
together and storing.
FAULTS AND REPAIR:
- If a fault is detected, check the following table: