Sunny Health & Fitness SF-T7610 Manual Del Usuario página 13

General cleaning will help prolong the life and performance of your treadmill. Keep the unit clean and
maintained by dusting the components on a regular basis. Clean both sides of the Running Belt (No.
C13) to prevent dust from accumulating underneath. Keep your running shoes clean so that dirt from
your shoes does not wear the Running Board (No. D12) and Running Belt (No. C13). Clean the
surface of the Running Belt (No. C13) with a clean, damp cloth.
To better maintain the treadmill and prolong its life, it is suggested that the treadmill be powered off
for 10 minutes every 2 hours and fully powered off whenever not in use.
CENTERING THE RUNNING BELT:
Place the treadmill on level ground and set it at 3-5mph to check if the Running Belt (No. C13) drifts
from the center.
1. If the Running Belt (No. C13) drifts to the
right, turn the right adjusting bolt ¼ turn
clockwise, then turn the left adjusting bolt ¼
turn counter-clockwise. If the Running Belt
(No. C13) does not move, repeat this step
until it centers. Refer to Figure A.
2. If the Running Belt (No. C13) drifts to the
left, turn the left adjusting bolt ¼ turn
clockwise, then turn the right adjusting bolt ¼
turn counter-clockwise. If the Running Belt
(No. C13) does not move, repeat this step
until it centers. Refer to Figure B.
3. Over time, the Running Belt (No. C13)
will loosen. To tighten the Running Belt (No.
C13) turn the Left & Right adjusting bolts
one full turn clockwise, check the tension of
the Running Belt (No. C13). Continue this
process until Running Belt (No. C13) is at
the correct tension. Make sure to adjust both
sides equally
alignment. Refer to Figure C.
MAINTENANCE & CARE
to ensure correct belt
12