Velux integra FMG-R Manual Del Usuario página 5

IMPORTANT:
The remote control for the blind is delivered with the blind.
The remote control delivered with the window cannot operate
the blind.
Initial set-up
A
The next three steps must be completed within 10 minutes.
1. Connect window to mains supply.
2. Remove strip from remote control.
3. Press RESET button (for 1 second) on the back of the remote
control with a pointed object.
The blind can now be operated.
Note: If the 10 minutes are exceeded, disconnect mains supply
and carry out initial set-up procedure again.
4 VELUX
B
C
D
E
ENGLISH ENGLISH
Operation
Keys for operating the blind (A)
OPEN or CLOSE
Short press: The blind will travel to maximum opening or clos-
ing position.
Long press: The blind will travel until the key is released.
Stop key (B)
Press: The blind stops.
Replacement of batteries
Insert new batteries (type AAA, 1.5 volt) as shown.
Fitting of holder for remote control
Note: Before the holder is fixed to the wall, it is recommended
to check if the remote control is able to operate the relevant
products from the fixed position.
Fixing of remote control
If required the remote control can be fixed to the holder.
VELUX 5