KNOVA KN DP-3000N Manual De Instrucciones página 7

ASSEMBLY AND ADJUSTMENTS
WARNING
If any part is missing or damaged, do not
plug the drill press in until the missing or damaged
part is repaired or replaced.
The column assembly (column, column support, rack, rack
collar, and table support bracket) must be attached to the
base. The table and table support handles must be attached to
the table support bracket. The head must be attached to the
column.
Tools needed for assembly (not included):
• Adjustable wrench
• Hammer and block of wood, OR dead blow hammer,
OR rubber mallet
• Screwdriver
ATTACHING COLUMN TO BASE (FIG. 3)
1. Place the column assembly (Fig. 3 - 1) on the base
(Fig. 3 - 2), aligning the column support holes to
the base holes.
2. Install a hex head bolt
(Fig. 3 - 3) in each column
support hole and tighten
bolts using the adjustable
wrench (not included).
Fig. 3
TABLE TO TABLE SUPPORT BRACKET (FIG. 4)
1. Place the crank handle (Fig 4 - 1) onto the shaft (Fig 4 - 2)
of the table bracket so the flat of the shaft is under the set
screw (Fig. 4 - 3). Tighten the set screw.
2. Thread the table lock handle (Fig. 4 - 4) into the front of
the table support bracket.
5
4
3. Thread
the table
support lock
handle into the rear of the table
support bracket (not shown).
4. Position the table (Fig. 4 - 5) in
the same direction as the base.
Install the table
and tighten
the table
lock handle
(Fig. 4 - 4)
and support
lock handle.
1
2
2
3
DRILL PRESS HEAD TO COLUMN (FIG. 5)
WARNING
injury, two people should lift it into position.
1. Carefully lift the drill press head assembly (Fig. 5 - 1) and
position it over the column (Fig. 5 - 2).
2. Place the mounting opening (Fig. 5 - 3) on the drill press
head over the top of the column. Make sure the drill press
head is seated properly on the column.
3. Align the direction of the drill press head with the direction
of the base and the table.
4. Tighten the set screw (Fig. 5 - 4) using the included hex
wrench.
FEED HANDLES (FIG. 6)
1. Insert the three feed handles (Fig. 6 - 1) into the threaded
openings on the feed hub (Fig. 6 - 2).
2. Manually tighten the handles into the openings. Use an
adjustable wrench (not included) to grip the flats on the
handles and fully tighten them.
NOTE: When using the drill press, one or two of the feed
handles may be removed
if an unusually-shaped
workpiece interferes
with the handle rotation.
1
2
Fig. 4
6
The drill press head is heavy. To avoid
4
2
Fig. 5
1
Fig. 6
1
3