JFA Electronicos X-LINE Manual De Instrucciones página 11

X-LINE SOURCES AND CHARGERS - INSTRUCTION MANUAL
Connect the battery to the charger and wait the indication light BATTERY LOADED
(charging time may vary depending on battery capacity and the source used). Read in display a
quantity from Amps than a battery Accumulated during o process from load.
Verify the value obtained is close to the amount of amperes specified by the battery
manufacturer (e.g. If the battery charged is 60A, the obtained value should be close to 60A). The
lower, in relation to the value indicated by the manufacturer, the worse the battery status. If a
battery bank is used in parallel, add the currents of the seat batteries.
(Note: When the meter reaches 999 it must be reset to continue reading the accumulated
charge on the battery).
VOLTAGE READING
The X-LINE Source display allows you to view the output voltage (in Volts) that is being
applied at that time to the system. To access this voltage value, press the SELECTOR READING
switch until the VOLTAGE INDICATOR LED lights up.
CURRENT READING
The X-LINE Source display allows you to view the output current (in amperes) that is
being applied at that time to the system. To access this current value, press the SELECTOR READING
switch until the CURRENT INDICATOR LED lights up.
CONTROL PANEL
BATTERY CHECK-UP
VOLTAGE AMPERAGE
READING
SELECTOR
1
CCA - Ri m
METER
MODE
SELECTOR
SELECTOR
SLOW AUTO OUTPUT BATTERY
s u p e r - x
CHARGE ICS VOLTAGE
PAINEL DE CONTROLE
CHECK-UP DA BATERIA
TENSÃO CORRENTE
SELETOR
LEITURA
1
MEDIDOR
CCA - Ri m
SELETOR
MODO
SELETOR
CARGA AUTO TENSÃO BATERIA
LENTA SCI
SAÍDA
SLOW CHARGE
PHASES
1.ELEVATION
2.ABSORPTION
3.EQUALIZATION
VOLTAGE CHARGED
BATTERY
CARGA LENTA
1. ELEVAÇÃO
2. ABSORÇÃO
3. EQUALIZAÇÃO
TENSÃO BATERIA
CARREGADA
9