Maytag Commercial MAT20PDFGW Instrucciones página 14

Connect Inlet Hoses to Washer
1. Attach hot water hose to hot water inlet valve marked
with a red ring. Screw coupling by hand until it is snug.
2. Attach cold water hose to cold water inlet valve marked
with a blue ring. Screw coupling by hand until it is snug.
3. Use pliers to tighten couplings an additional two-thirds turn.
NOTE: Do not overtighten. Damage to the valve can result.
4. Turn on water faucets to check for leaks. A small amount of
water may enter washer. It will drain later.
NOTE: Replace inlet hoses after five years of use to reduce the
risk of hose failure. Record hose installation or replacement
dates on the hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
POWER CORD REPLACEMENT
INSTRUCTIONS
The steps in this section shall only be performed by a Maytag
service person, qualified electrician, or similarly qualified person.
14
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. The appliance shall be disconnected from the power
supply before servicing. Read all instructions before any
disassembly.
2. Remove retaining screw securing power cord assembly to the
product and save for re-installation.
Retaining
Screw
3. Rotate the power cord strain relief bracket within the machine
console and remove at an angle from the opening in the
back panel to expose access to the inner connector. The
inner connector is still connected. Do not put strain on the
conductors while removing the bracket to allow access to the
connector.
Twist
Remove at
Angle
Outside Product
4. Disengage the supply connection within the product by
depressing the connector clip to release the power cord from
the appliance.
Press
Inside Product