LUND 82991 Manual De Instrucciones página 7

EN
Never leave the product unattended if the power cord plug is connected to the electrical system.
During use, the pump must be submerged under the water surface at all times. Operation without water will lead to overheating
and irreversible damage to the pump.
PRODUCT OPERATION
Place the pump under the water surface so that the entire pump is submerged (II).
Make sure that the switch is in the "off " position - O. To do so, press the switch and move it to the off position.
Plug the power cord plug into the electrical system.
Direct the shower outlet to a safe place, away from electrical equipment.
Move the switch to the "on" position - I.
Wait until water begins coming out from the shower outlet.
Do not pull the pump out of the water during use. If this happens, the shower will not function properly when the pump will be put
back into the water. If the water does not fl ow out of the shower after the pump has been placed in the water, turn the shower off
with the switch, disconnect the power cord plug and then hold the hose vertically so that all the water fl ows out (III). Place the pump
under the water surface and restart the shower according to the procedure described above.
When you have fi nished showering, turn the shower off with the on/off switch. Disconnect the power cord plug from the electrical
system socket, and then hold the hose vertically to allow the water to fl ow out entirely (III).
Next, proceed with maintenance.
Shower adjustment
The shower has a stepless adjustment of the water jet intensity (IV). Moving the adjuster in the direction marked "Min" will reduce
the water fl ow, but will not be able to stop it completely. Moving the regulator in the direction marked "Max" increases the intensity
of the water jet.
The hand-held shower head is equipped with a wall-mounted bracket with a suction cup or hook. This allows you to hang the
shower head (V).
MAINTENANCE, TRANSPORT AND STORAGE
After use, the product must be completely emptied of water. This will prevent the development of microorganisms within the water
system and will also prevent damage to the product which could be caused by freezing water.
Unscrew the pump retainer and pull out the pump's sponge fi lter (VII). Rinse the fi lter and the retainer with lukewarm running
water, then dry and attach back to the pump. It is forbidden to use the pump without the installed fi lter.
Clean the product's external surfaces with a slightly damp cloth, then dry or leave to dry.
The product should be transported and stored in the included cover. Store the product in shaded and well ventilated places. The
storage place should prevent unauthorised access to the product.
This symbol indicates that waste electrical and electronic equipment (including batteries and storage cells) cannot be disposed of with other types of waste. Waste equipment
should be collected and handed over separately to a collection point for recycling and recovery, in order to reduce the amount of waste and the use of natural resources. Un-
controlled release of hazardous components contained in electrical and electronic equipment may pose a risk to human health and have adverse eff ects for the environment.
The household plays an important role in contributing to reuse and recovery, including recycling of waste equipment. For more information about the appropriate recycling
methods, contact your local authority or retailer.
O R I G I N A L I N S T R U C T I O N S
7