Magneti Marelli M-MX4000 Manual De Operación página 9

3. Cycle operation 15 min
After having switched on the button 15 min, the device is running for 15 minutes.
4. Cycle operations 30 min
After having switched on the button 30 min, the device is running for 30 minutes.
Caution:
1. To ozonate water or other liquids, connect one end of the 1.0 m long hose to the ozone output socket and the
other end to a diffuser block.
2. To ozonate air, do not connect any hoses or diffuser blocks.
3. Plug the power cable into a mains outlet.
Caution: The power outlet ratings must match the nameplate data
of the machine. See the nameplate on the machine. THE POWER OUTLET MUST HAVE A PE (PROTECTIVE
EARTH) CONTACT.
GUIDELINES FOR OZONE THERAPY APPLICATION
When using the generator to ozonate liquids, place the machine at least 20 cm above the liquid level to prevent
the medium from flowing into the generator. When using the generator to ozonate air, do not connect any hoses
or diffuser blocks.
WARNING: Place the machine base at least 20 cm above the surface of the liquid to be ozonated.
MAINTENANCE
If the M-MX4000 is used sporadically, keep it in a dry place in a plastic bag for protection against dust. If you
decide to operate the machine with the automatic ozone distribution system, regularly inspect it to make sure
that the system works properly and efficiently:
• Check all lines and connections for damage and leaks.
TECHNICAL SPECIFICATIONS AND OPERATING CONDITIONS
Model: M-MX4000
Ozone generator output: 3000-4000 mg/h
Internal pump output: 10-15 l/min
Programmable time counter: 1-60 min
Pump pressure output: 17 kPa
Operating conditions: use inside well-ventilated rooms without any corrosive gases in the ambient air
Ambient pressure: 100±4 kPa
Ambient temperature range: 5-40°C
Relative ambient humidity: ≤ 80%
Ozone generation process: coronary discharge
Output line diameter: 8 mm
Power supply: AC, 220-240 V 50 Hz