Publicidad
Idiomas disponibles
Idiomas disponibles
Rear camera installation
We recommend install the rear camera above the license plate.
1. Fix camera with 3M adhesive
Find a best location tear off the 3M adhesive on the rear camera, fix the
rear camera near by the car license plate lamp. (if you need to adjust
the angle, please attach the rear camera bracket to the rear camera and
tighten it with screws first).
2. Remove the Panel
Remove the inner panel of the trunk to expose the rear wiring
compartment of the car. Open the trunk and look for a sturdy inner
panel covering the other side of the license plate installation area. Then,
insert a decorative removal tool or another thin device behind the panel
and pry it apart.
3. Install the cable
Look for lights near the license plate that have gaps to allow wires to pass through. Run the rear
camera cable through the gap into the trunk of your car.
10
Publicidad
