Batavia MAXXPACK BT-CB001 Manual De Usuario página 9

Assembly
4.1.
a. Place the motor unit (17) and the power
supply unit (5) with the tube ends facing
each other.
b. Slightly pull the socket (20) using the tug
strap (21) and the plug (22) out of the tube
ends. (see Fig. B)
c. Connect the socket and the plug with the
arrows pointing towards each other and
screw together tightly.
d. Connect the two tube ends (arrows
pointing towards each other) and screw
them together with the grip sleeve (2).
e. Plug the hose (13) into the connection on
the motor unit. (see Fig. C)
f. Guide the hose through the retaining
clip (1) and the mount on the motor unit.
Make sure that the hose on the motor unit
is long enough so that the adjustable
brush head can move without restriction.
g. Connect the hose adapter (11) to the hose.
h. Slide the hose adapter onto the guide track
of the attachment clip (12). (see Fig. D)
5. Intended use
This product is intended for cleaning surfaces
indoors and outdoors in the domestic sector.
The product can be operated dry or with water.
It is not intended for permanent commercial
use.
The intended use also includes an operation
following the operating instructions.
Any use beyond these parameters (different
media, applying force) or any changes (recon­
struction, no original accessory) can lead to
serious risks and is regarded as use that is
contrary to the intended purpose.
Only use accessories recommended by
supplier.
6. Use
Inserting/changing the battery
6.1.
The battery cover protects the battery from
moisture and debris.
a. Only use the device with water when the
battery cover is properly closed.
b. Make sure the battery cover's seal and
rubber edge is clean and dry.
a. Undo the locking clip (6) and open the
battery cover (7).
b. Insert or take out the battery (see Fig. E).
c. Always check the seal before closing the
battery cover!
Remove dirt and foreign objects in the
area of the seal and check whether the
seal is present and undamaged.
d. Close the battery cover and lock it with the
locking clip.
Attaching/changing the brush
6.2.
a. Block the shaft with the shaft lock
button (16) and screw on the outer part of
the brush (15) in the clockwise direction
(see Fig. F).
b. Insert the inner part of the brush (14) and
lock it in place in the counter-clockwise
direction.
c. To undo the inner part of the brush, unlock
it in the clockwise direction and take it off.
d. Block the shaft with the shaft lock button
and unscrew the outer part of the brush in
the counter-clockwise direction.
Adjusting the tilt angle of the brush
6.3.
When using the device on the ground / floor,
the head should not be locked. The head can
then move along with the surface to be
cleaned.
Only lock the head when using the device
above shoulder height.
a. Lift the locking lever (18) all the way (see
Fig. G).
b. Adjust the tilt angle to your individual
needs and fix it in place by pushing down
the locking lever.
Do not push the locking lever through with
great force. If the locking lever does not
close properly, adjust the inclination of the
brush slightly.
Adjusting the extra handle
6.4.
a. Undo the locking screw (3). (see Fig. H)
Before the first use
9