Hiltron security IR364 Manual Del Usuario página 4

IR364
The connection to the anti-theft central must be done according to the following way:
FUNCTIONNEMENT
At the power of detector the LED flashes for approximately a minute; in this phase there is the stabilized
the sensibility of the pyroelectric sensor.
After the necessary time to the stabilization, the LED is off
The activity of detection of presence opens the contact of escape NC and is signalling from the fixed
ignition of the LED that hard approximately 5 second ones; contact NC is restored after approximately 3
second ones from the term of the detection.
With the dip-switch 1 in position ON it is possible to limit the sensibility of detector IR364.
With the dip-switch 2 in position ON it is possible to activate the function pulse counter;the opening of
the contact of hard escape NC approximately three second ones and comes only executed after 6 impulses of
detection (signals to you from flashes of the LED), or after a continuous detection at least 3 second ones. If
during the time of a minute the counter does not come counter no impulse it comes annulled.
With the dip-switch 3 it possible annulled the signaling LED
The dip-switch 4, if prensent,is not utilizzed
ALARM MEMORY
The alarm memory function of the detector is useful when more detectors are installed on the same
zone; in such case, in fact, if the zone filler a memory alarm, with the traditional detectors is not possible to
know the detector that it has caused l' alarm; with l' IR364, instead, will be possible to identify it.
Is necessary to connect positive interrupted the coming one from it in such a way centers them antitheft
(+ Int.) on clip M. inserting l' active antitheft system the memory function alarm in the detector, that it comes
marked from I flash of approximately 5 second ones of the LED; in this starting phase is annulled them l'
eventual memory already present alarm on the sensor.
After approximately 20 second ones dall' insertion, l' detection activity (understanding as opening of
contact NC) comes memorizzata sull' IR364 and will be marked, to every successive detection, through l'
ignition blinking of the LED and not more fixed.
Such condition persists also in the disinserimento dell' system; it will be restored to the armed the
enabling the system
4
Connection
for tamper
security
Burglar central unit