JL Audio Fathom f113v2 Manual Del Propietário página 22

RECEIVER / PROCESSOR (UNBALANCED OUTPUTS)
FRONT
FRONT
ilt in USA with Imported and domestic components
F 12A H
250V
0 V ~ 60 Hz
1200VA
WARNING! TURN OFF THE FATHOM v2 AND ALL OTHER EQUIPMENT IN THE
SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
EN | Pg 22
PRE OUT
L REAR CENTER
OR
R REAR SUB
INPUTS
Input Modes
Slave Slave Grounded
LEFT
or
MONO
z
Master Master Isolated
Unbalanced Balanced
Output to Slave
(Balanced)
RIGHT
ONLY
SERIAL NUMBER:
Warranty void if serial number is removed, altered or defaced.
FATHOM REAR CONTROLS (MASTER)
PROCESSOR (BALANCED OUTPUTS)
OUTPUTS
SYSTEM CONNECTION DIAGRAM 1:
One Fathom v2 to
Home Theater Receiver or
Home Theater Preamp/Processor
Most home theater receivers and
preamp/processors provide a single
(mono) subwoofer output. When
connecting a mono subwoofer output
to your Fathom v2, you will only use the
Fathom's "Left or Mono" input.
Two connection types are available
for connecting the Fathom v2 to your
home theater system: balanced (XLR or
1/4-inch TRS connector) and unbalanced
(RCA-type connector). Balanced
connections provide superior noise
rejection and ensure proper grounding
between components. If your receiver or
processor has balanced outputs, we highly
recommend that you use them.
In the connection diagram at left,
balanced connections are shown as solid
lines, unbalanced connections are shown
dotted. You will only use one of these
input connection methods (not both).
WARNING
| Fathom
v2
®