Moni FLORENCE Manual De Instrucciones página 13

Illustration A – Unfolding of the stroller frame: Unhook the folding mechanism, lift the handle until the tube locks in
place, you should hear a clicking sound.
Illustration B – Installation of front and rear wheels. Using of the brake:
- Installing and removing the front wheels (B1 и B2): As shown in Figure B1, insert the front wheel into the
front frame hole. Fix it until you hear a "click". To remove the front wheels, press the button and the wheels
are removed easily by pulling (Figure B2).
- Assembling and removing the rear wheels (B3): As shown in Figure B3, insert the rear wheel into the hole of
the rear frame. Fix until you hear a click. To remove the rear wheels, push the button and the wheels are
released quickly by pulling.
- Using of the linked brake (B4):
pedal on the rear axle (Figure 4A). To release the brake, pull up the pedal using your foot (Figure B4).
Illustration С – Seat assembly. Adjusting the footrest:
- Seat Assembly (C1) – To install the seat, put it in the frame holes until you hear a click sound (Figure C1). To
remove the seat, press the buttons on both sides at the same time. Then, pull the seat up to remove it.
- Adjusting the footrest (C2) - As shown in Figure C2, move the step up and the angle can be adjusted. To adjust
the footrest, hold the button on both sides for its release.
Illustration D – Attaching the safety board. Adjusting the position of the handles:
- Attaching the safety board (D1): Insert both ends of the safety board into the two side holes of the frame.
Secure the guard until you hear a click (Figure D1). To remove the guard, press the release button on both
sides of the frame and pull at the same time.
- Adjusting the position of the handles (D2): As shown in Figure D2, the position of the handles can be adjusted
by pressing the two side buttons of the frame and moving the handle to the desired position.
Illustration Е – 5-point safety belt: Follow the steps, described in Figure Е. To attach the belt, insert the two tabs of
the lap belt into the buckle on both sides, should click when properly inserted. The shoulder straps are fitted as the
metal tabs are assembled and inserted into the buckle. The sliding adjusters are fitted and must be carefully adjusted
on each side so that the belt is fastened around your child without causing discomfort. To release the bely, press the
buckle button, and pull to open.
Illustration F – Changing the direction of carry cot: To change the direction of the carry cot press the button as shown
in Figure F. Pull out the carry cot, then turn it over to the desired direction and put it back into the designated holes.
Illustration G – Folding of the stroller frame: Before folding the stroller, you must engage the parking device, fold the
canopy, and empty the luggage basket. Then follow the sequence of steps described in Figure G. Press the thumb and
push button on the pushchair folding mechanism at the same time. Push the handle forward until the stroller folds.
Remove the handle.
Attention! When closing the trolley, make sure your child or other children are kept at a safe distance. Make sure the
moving parts of the trolley do not come in contact with your child during these operations. Before closing the cart,
make sure the luggage basket is empty.
1. Regularly check the locking devices, brakes, safety belts and buckles, connectors, and fixing mechanisms in order to
be sure that they are in good working order and are not worn or damaged.
2. If you find loose, broken, and damaged parts, they should be repaired by an authorized service or replaced with
original parts. Otherwise, the warranty of the stroller will be annulled.
3. Do not make modifications on the construction and do not replace the work parts with ones that are поt suitable
and are not original. This may lead to incorrect functioning of the stroller and to injury of your child. And also to
annulment of your warranty of the stroller.
4. In order to clean the cover, the dirty plastic and metal parts of the product, use soft cotton cloth or sponge, wetted
with water.
5. Never clean with agents containing abrasive particles, ammonia, bleach, or alcohol. DO NOT wash in the laundry
the removable and accessories – parts and accessories – canopy, etc., because this may lead to their damage.
Otherwise, the warranty will be annulled.
6. Always after cleaning leave the stroller to dry completely and afterwards use it or store it.
7. Store the stroller indoors. The effects of the environment – sea air, roads sprinkled with salt, acid rains, etc., as well
as the storage outdoors lead to the emergence of corrosion.
To activate the parking device and lock the two rear wheels, press down the
INSTRUCTIONS FOR MAINTENANCE AND CLEANING
13